Usage & Maintenance Guide

The flow rate of sand art is adjusted, you don't need to make any adjustments in general. When used for a long time, you can make certain adjustments according to your own needs.

Maintenance of quicksand art

As the tempetature and pressure change, sometimes you wil need to adjust the air and water. The height of air layer is about 1cm, and the sand will reach a relatively good flow rate.In general, there is no need to adjust the air and water.

The quicksand falls too slow, pulls out some air.

The quicksand falls too fast, add some air.

If many small bubbles in the quicksand layer become a particularly large bubbles, a little water can be filled at this time to supplement the evaporation of water.

1. Be sure to use pure water.

2. Select a air hole, remove the sand, draw out some air, and empty the regulator tube.

3. Use the regulator to pump in and add the same amount of water.

Not to add too much water at once, lest the pressure is too high to break glass.